Best Practices for DOCSIS 3.1 Phase Noise Design in the Remote PHY Node
By Zhuo Zhao, Jiayou Meng & Haibin Tang, Cisco System
|
2017 |
Analysis of Cable System Digital Transmission Characteristics
By Richards. Prodan, Majid Chelehmal,Thomas H. William, Craig M. Chamberlain, Cable Television Laboratories, Inc.
|
1994 |
Wide Dynamic Range Carrier-to-noise Testing
By Rex Bullinger, Hewlett-Packard Company
|
1993 |
Leading Edge Photonic Technologies
By T. E. Darcie,
AT&T Bell Laboratories
|
1992 |
Advances In Technology And New Installation Configurations Suggest Mechanical Modifications In CATV Amplifier Housings
By Scot Milne, Magnavox CATV Systems Company
|
1989 |
Method For Including CTBR, CSO, And Channel Addition Coefficient In Multichannel Am Fiber Optic System Models
By Ernest M. Kim, Mark E. Tucker, and S. Lee Cummings
|
1989 |
On The Use Of High Efficiency Power Supplies
By Dan Pike, Prime Cable Corp.
|
1986 |
Powering The Off-Premises Signal Control System
By W. Sherwood Campbell, American Television & Communications
|
1985 |
Thermal Noise Revisited
By Dr. Harold W. Katz, Stern Telecommunications Corporation
|
1983 |
Power Supply Requirements And Voltage Calculations For Cable Powered CATV Systems
By James K. Waldo
|
1979 |
Co-Channel Protection Limitations Of The Circularly Polarized ( CP) Antenna-Array
By Steven I. Biro,
Biro Engineering
|
1978 |
Developmental Approaches For An Existing Cable System
By Fernando Ciccone and Dean Adrian, Manhattan Cable TV
|
1978 |
Increasing The Channel Capacity Of Single Ended CATV Amplifiers
By E. W. Finlay, York Cablevision Limited and J. Cappon,
J. Cappon & Associates Limited
|
1975 |
On The Realities Of Non-Linear Distortion In CATV Amplifiers
By Jacob Shekel, Jerrold Electronics Corporation
|
1973 |
Programable Calculators As An Aid In System Design
By W. Richard Thompson,
Warner Cable Corp.
|
1973 |
Operational Transformation Using GIS
By Derek Rieckmann, Midco
|
2019 |