In-Service Noise Measurements On A CATV System (1971)

By Charles W. Rhodes, Tektronix, Inc.

Measurement of the signal-to-noise ratio in communications systems is of fundamental importance - both in evaluating performance and in planning preventative maintenance.

By clicking the "Download Paper" button, you are agreeing to our terms and conditions.

Similar Papers

In-Service Noise Measurements On A CATV System
By Charles W. Rhodes, Tektronix, Inc.
1971
Noise Measurements For A CATV System-C/N,S/N,phase Noise
By Wen Tsung Lin and Tim Homiller, Jerrold - Applied Media Lab
1989
Key Frequency Parameter Measurements And Instruments
By Linley Gumm, Project Engineer, Tektronix, Inc.
1972
CATV System Design and Operation
By C. Bailey Neal, Archer S. Taylor, Donald W. Levenson, Orville D, Page, J.D. Cauldwell, P. Knight and E. R. Mertz, John Campbell and Joseph P. Gleason
1969
Oscillator Phase Noise And Its Effects In A CATV System
By Rezin Pidgeon, Principal Engineer, Scientific-Atlanta Dan Pike, VP Engineering, Prime Cable
1988
Noise Figure And The System Signal To Noise Ratio
By Carmine D'Elio, Vikoa, Inc.
1967
Airspace Measurement Of CATV System CLI
By Leslie W. Read, Field Service Engineer, Sammons Communications, Inc.
1986
Noise Figure Measurements On Distribution Systems
By Donald E. Groff, General Instrument Jerrold Division
1984
Specialized Test Equipment For CATV Distribution Measurements
By George P. Dixon & Thomas F. Kenly, C-COR Electronics, Inc.
1971
Noise Accumulation in CATV Distribution Systems Employing 1550-nm Externally Modulated Transmitters
By D. Atlas and R. Pidgeon, Scientific-Atlanta, Inc.
1994
More Results >>